Fiber Guide Pins Fiber Holder. The fibers stop moving forward at the Gapset position. Failure to follow the above instructions may cause abnormal arc discharge. See the seller's listing for full details. If the blade is Large end-face. Sheath Clamp 1 Open wind protector and sheath clamps. Do not attempt to use this machine for other applications.
It is small in size and light in weight, making it suitable for any operating environment. . . Perform this function in the event of splicer operation trouble. At that time extend the heating time. Splice loss is affected by certain factors stated in the next page. Cleaning V-grooves If contaminants are present in the V-grooves, proper clamping may not occur, resulting in higher splice loss.
Dust Check The splicer observes fibers through image processing. Power On Option in Machine Settings Set Opening title and Password Lock function Parameter Descriptions Sets the message to be displayed when the power is turned on. Cutting lever Stopper 2 Push the slide button until it locks. Pull and unlock wind protector mirror latch with fingers. A set of splicing parameters is selected for the identified fiber type and the fibers are automatically spliced. Battery operation Check and make sure the remaining battery capacity is 20% or greater before operation otherwise few splices can be made.
Tightening the original screw without the protector may damage mechanism inside. This may result in electric shock. The following procedure is required, and is different from standard automatic splicing. An environmental performance decreases when the protector is detached. Other Necessary Items for Splicing Operation Fiber coating 0. After executing the arc calibration, the splicer will repeat arc discharge 45 times in succession to stabilize the electrodes. This splicer is equipped with temperature and pressure sensors that are used in a constant feedback monitoring control system to regulate the arc power at a constant level.
This function automatically calibrates the speed of all six motors. Camera Image This function is to store the fiber image after splice or error occurred. List of Splice Results Splicing results stored in the memory can be displayed. Packaging should be the same as what is found in a retail store, unless the item is handmade or was packaged by the manufacturer in non-retail packaging, such as an unprinted box or plastic bag. Straps for small accessories may be recommended. These factors are taken into account to calculate, or estimate, splice loss.
. Set Calendar This function sets the date and time in the calendar incorporated in the splicer. This section describes how to use the maintenance menu. Such abnormally high voltage or frequency from a generator may cause fuming, electric shock or equipment damage and may result in personal injury, death or fire. If the battery pack is recharged repeatedly even though a sufficient capacity still remains, a memory effect would make it seem as if the battery capacity has decreased. Password input screen is displayed.
However, settings could change due to various reasons. Comments can be added or edited. The splicer automatically identifies the type of power supply unit. To get a stable low splice loss 1-1. Dust particulates from the fiber coating surface can enter inside the protection sleeve and might result in a future fiber break or attenuation increase.
This may result in electric shock, splicer malfunction or poor splicing performance. Cards accepted: Visa, MasterCard, Discover Card, and American Express. For this reason, Fujikura Ltd. Visual inspection with the monitor is often necessary for better splicing yield. Adhere to all safety instructions and warnings contained in this manual. Selecting Heater mode Select the heater mode most suitable for the protection sleeve to be used. Press Escape key to exit.